Requirements for operating CNC machining centers

The correct operation and maintenance of CNC equipment can prevent abnormal wear of the machine tool and avoid sudden failure of the machine tool. Careful maintenance of the machine can maintain the long-term stability of the machine's machining accuracy and prolong the service life of the machine. CNC part machining center manufacturers take this work seriously.

Basic requirements for operating CNC machining centers:

1. The working temperature of the equipment should be controlled between 15 and 35 degrees. The precision processing temperature should be controlled at about 20 degrees, and temperature fluctuations should be strictly controlled.

2. In order to avoid large power fluctuations (greater than or less than 10%) and possible effects of instantaneous interference signals, CNC equipment is usually powered by dedicated lines (such as machine tools separated from CNC's low-voltage power distribution room) and voltage regulators. Reduce the impact of power quality and electrical interference.

3. Requires the use of CNC equipment to avoid humid, dusty, and non-corrosive places;

4. Avoid direct sunlight and other heat radiation. The precision CNC equipment should be far away from the equipment with large vibration, such as punching machine, forging equipment, etc .;

Person in charge of maintenance:

1. Equipment maintenance personnel are responsible for equipment maintenance and necessary maintenance;

2. Workshop management personnel are responsible for operator supervision and equipment maintenance of the entire workshop.

3, the operator is responsible for the use, maintenance and basic maintenance of the equipment;

Maintain daily machining accuracy:

1. Before closing, place the table and saddle in the center of the machine (turn the three-axis stroke to the middle position of each axis stroke);

2. The machine tool should be kept dry and clean.

3. After starting, warm up for about 10 minutes before processing; machines that have not been used for a long time should extend the warm-up time;

4, check whether the oil circuit is unblocked;

All in all, this is to maintain the service life of CNC intelligent machine tools. I hope the introduction of CNC intelligent machine tools will be helpful to you.